Bromine Infused Granules (5kg)

1. Use spa test strips and pH balance products to maintain pH level within the ideal range of 7.2 – 7.6. If the level is not in this range, adjust. 2. Maintain bromine residuals for spas within the range 3 -5 mg / l (ppm). *Freshly filled spas require initial shock to start up dose of chlorine: 50 mg / l (ppm) for 1 hour or 20 mg / l for 2 hours. 3. These bromine granules may be applied directly to spas where temperatures exceed 20 degrees C. If below this temperature or if in doubt pre-dissolve the chlorine granules in a clean plastic container at a maximum rate of 10 g of product per 1 litre (0.2 gallons) of water. Stir well to ensure the chlorine is fully dissolved. Carefully add the resulting solution to the spa whilst the pump(s) are turned on, preferably near the water inlets and jets to aid distribution. 4.Repeat dose application if necessary to achieve levels in point 2 above. 5. Use spa test strips to check the chlorine level is within the range 3 – 5 mg / l (ppm) before bathing recommences. 6. It is recommended that you periodically shock dose your spa with AquaSparkle SpaFusion. ALWAYS ADD CHEMICALS TO WATER & NOT WATER TO CHEMICALS. NEVER MIX CHEMICALS.